KUNSHAN WONDERTEK TECHNOLOGY CO.,LTD.
Smooth communication makes intelligent life!
Add to Cart
Brief introduction
The product transmits the network signals through the existing power line, not need to wire, where is a socket there is a network. The signal is stable and not be influenced by the obstacles. It is easy to use, just plug and play. It supports 128-bits AES data encryption, can insure the safety of data transmission. It’s stable function, strong anti-interference ability, higher level anti-thunder ability and advanced manufacture technique make the product can meet more demands of the market.
Topology
Specification
| Specification | |
| Model | WD-1000M-G(Industrial grade) |
| Interface | 1*LAN 10/100/1000Base-TX self-adapt RJ45, |
| 1*AC220V power interface, support MDI/MDX | |
| LED display light | LAN PLC PWR |
| Transmission band | 25,50 and 100MHz and MIMO (based on G.9963) |
| Protocol(PHY) | IEEE802.3,IEEE802.3x, IEEE802.3u G.hn |
| Security | 128-AES |
| Transmission rate(PHY) | 800Mbps |
| Modulation | OFDM |
| Management | Firmware remote update,support TR-069(optional) |
| 802.1D Ethernet Bridge | |
| 802.1Q VLAN | |
| Quality of Service(QoS) | |
| IGMO(IPv4)Snooping&MLD(IPv6)Snooping | |
| Working voltage | AC 85V-265V 60/50Hz |
| Working temperature | -40℃-80℃ |
| Size | 159*65*32mm(L×W×H) |
| Weight | 0.28kg |
| Working environment | Working humidity:10%-85% no condense |
| Storage humidity:5%-90% no condense | |
| Certification | FCC,CE class B,WEEE,RoHS |
Features
Packet loss rate: less than 0.01% (100 m, 70% load measurement) ;
Support 7 * 24 hours work ;
Have hardware watchdog function ;
PING value is less than 1 ms.
Electrostatic discharge reactance immunity:
The test voltage monitoring unit should be able to withstand: ±6kV Direct discharge ,±8kV air discharge. Discharge time in each sensitive test sites: The positive and negative electrodes 10 times each ,each discharge interval 1s,The test procedure follows B/T 17626.2-2006.
Electrical fast transient bursts (common mode) immunity:
The test voltage monitoring unit should be able to withstand: The voltage between power supply port and ground :±2.0kV,Between signal circuit and earth :±1.0kV,repetition frequency :5KHz,Testing time:1min/time Testing voltage times: The positive and negative electrodes 5times each. The test procedure follows B/T 17626.2-2006.
Surge immunity (impact)
The test voltage monitoring unit should be able to withstand: ±2kV,Time interval between successive pulse :1min/time, testing time: The positive and negative electrodes 5times each. The test procedure follows B/T 17626.2- 2006. (Protection adopts the model of full protection and the varistor connects discharge tube in series )
Vibration defending
Meet TB1433 MX3 level requirements (0~200HZ, 2g accelerated speed, maximum amplitude 7mm),in the Testing process, it demands the interface no looseness, device desoldering and falling.